top of page
Other manufactured items

MOTION CONTROL INTERFACE - ( Cine CCU )

The MOTION CONTROL INTERFACE slaves the camera to Motion Control rigs. These rigs normally have STEP / DIRECTION outputs to drive dc and stepper motors. The Cine CCU input takes these signals from the MoCo computer and then runs and phases the camera so the shutter is always in the same relative speed and position. This allows possibilities such a double exposure pan where each frame is exactly taken over the previous take.

 

IRIS DRIVER-

The Iris Driver unit connects between the Computach and a standard "Heden " type motor to give iris compensation for speed changes, or other lens control.

 

REMOTE RADIO -

The RS 232 COMPUTACH to camera radio link is shortly available.

 

REMOTE CABLE -

The COMPUTACH may be used on long cable for remote heads, cranes, planes, helicopters.

A 232 3/2 wire interface is also available super long, modem and radio.

Synccine Motion Control systems are designed and engineered as cost effective, light weight solutions for both DSLR cameras and heavier duty motion picture cameras.

 

© 2013 by Synccine.

SYNCCINE

Contact: Glenn Anderson

106 Darebin Bvd,

Reservoir, Melbourne,

Australia, 3073

Ph (61) (0) 409 380 587

glennsc@synccine.com

  • Facebook Classic
bottom of page